Heatese heats the surface indirectly. Instead of the flame heating a metal surface, our flame heats a container of air. Air then rises and heats the internal surface of the copper tank.
The heat is then transferred to the water within the tank. Much more fuel efficient. The method is vastly more efficient as it requires far less fuel to heat air. Once it reaches temperature only a very small amount of energy is required to maintain the heat.
Heating indirectly also allows us to use copper which is a better conductor.
Heatese heats water indirectly, making it much more efficient at heating water than conventional boilers.
The temperatures inside the Heatese Gas Chamber reach 324°C. By the time these gases leave the exhaust system they
have been reduced to 40°C. This is done by the energy recovery system which transfers the otherwise lost heat back into the system. By recycling the heat additional fuel is not being used to create more heat.
If turned off for 24hrs the Heatese system will cool by 5°C. Heatese stores its energy for when it’s required. It can be run for a few hours a day or constantly.
A conventional boilers uses up to 40% more oil in its first hour of operation and will lose its heat quickly once turned off, requiring a pre-heat period again.
Heatese stores a large volume of heated water, so there is no extra cost in relation to pre-heating
A more efficient smaller boiler replaces a larger boiler thus reducing fuel requirement
Typically a 36kw boiler replaces a 190kw boiler - you still get same output of heat